No-Wake Mode Control - Yamaha WaveRunner FX SHO Service Manual

GEN
INFO
Technical tips

No-wake mode control

The no-wake mode has been added as a new function. The no-wake mode is a function for operat-
ing the watercraft at a low speed to limit the watercraft's wake. In this mode, the ECM automatically
maintains the engine speed at approximately 2,100 r/min. When the no-wake mode is activated, "5"
(when miles are selected) or "8" (when kilometers are selected) starts flashing in the digital speed-
ometer display to inform the rider that the mode has been activated. The no-wake mode cannot be
activated immediately after starting the engine. After starting the engine, wait for 5 seconds or more
before activating the mode.
To activate the no-wake mode:
Push and hold the "NO-WAKE MODE" switch. When the no-wake mode is activated, the beeper
sounds 3 times quickly and "5" (when miles are selected) or "8" (when kilometers are selected)
starts flashing in the digital speedometer display. Keep the throttle lever in the idle position when the
no-wake mode is activated.
To deactivate the no-wake mode:
Perform one of the following procedures to deactivate the no-wake mode.
• Push the "NO-WAKE MODE" switch.
• Squeeze the throttle lever.
• Move the shift lever to the reverse position.
• Stop the engine.
The beeper sounds 2 times quickly and the digital speedometer display stops flashing when the no-
wake mode is deactivated.
1 "NO-WAKE MODE" switch
Number of
beeps
1
No-wake mode operation
Activated
Deactivated
1-44
Digital speedometer
display
Starts flashing
Stops flashing
E
1
2
3
4
5
6
7
8
9