Remote Control Transmitter - Yamaha WaveRunner FX SHO Service Manual

– +
ELEC
Remote control system
5
7
2. Push the lock button 5 or unlock button 6
6
NOTE:
• At this time, the system enters the registra-
tion mode to register the first code. All exist-
ing ID codes will be deleted from the remote
control receiver.
• The "UNLOCK" indicator light 7 blinks when
the registration of the ID code has been com-
pleted. (If the registration could not be com-
pleted, the "UNLOCK" indicator light comes
on. Re-transmit the ID code.)
3. After confirming that the registration of the
NOTE:
• Up to 5 remote control transmitters can be
registered in any sequence, regardless of
whether they are original equipment or addi-
tional transmitters.
• The same ID code cannot be registered
twice in the remote control receiver.
4. After ID code registration has been com-

Remote control transmitter

1. Check:
7-60
to transmit the ID code from the remote
control transmitter to be registered.
ID code has been completed using the
"UNLOCK" indicator light 7, transmit the
next ID code.
pleted, disconnect the entry box to exit the
registration mode.
• Remote control transmitter operation
Does not operate → Measure the
remote control transmitter battery volt-
age or check the remote control
receiver.
E
1
2
3
4
5
6
7
8
9