Huawei EchoLife ET323 User Manual page 44

EchoLife ET523 IP Phone User Manual
Field
Via TFTP
Via HTTP
Firmware Server
Path
Config Server
Path
Firmware File
Prefix
Firmware File
Postfix
Config File
Prefix
Config File
Postfix
Description
This is the IP address of the configured TFTP server. When it is
selected, if the value is non-zero or not blank, the ET523 will
attempt to retrieve a new configuration file or a new code image
from the specified TFTP server at the boot time. With three
attempts before timeout, it will start the boot process with the
existed code image in the Flash memory. If a TFTP server is
configured and a new code image is retrieved, the new
downloaded image will be verified and then saved into the
Flash memory.
Note:
When adopting the TFTP upgrading software, you are
strongly recommended to upgrade the firmware in the local
LAN environment. Do not interrupt the TFTP upgrade
process (especially the power supply) to prevent from
damaging the device.
The URL of the HTTP server used for firmware upgrade and
configuration through HTTP, such as:
http://um.huawei.com/etphone:6688/.
Here " :6688"is the specific TCP port that the HTTP server is
using. It is omitted when the default port 80 is used
Note:
If Auto Upgrade is set to No, the ET523 will only perform
HTTP download when it boots up.
IP address or domain name of firmware server.
IP address or domain name of configuration server.
The default setting is blank. If it is configured, the phone will
request the firmware file with the prefix. This setting is useful
for ITSPs. The end user should keep it blank.
The default setting is blank. The end should keep it blank.
The default setting is blank. The end should keep it blank.
The default setting is blank. The end should keep it blank.
39
4 Configuration Guide