Huawei EchoLife ET323 User Manual page 47

EchoLife ET523 IP Phone User Manual
Field
Distinctive Ring
Tone
System Ring
Tone
Call Progress
Tones
Disable Call
Waiting
Disable
Call-Waiting
Tone
Use Quick IP
Call Mode
Lock Keypad
Update
Description
Custom ringtone 1– 3.
Caller ID: When a ringtone is selected, if a caller ID is
configured, then the device will only play this ringtone when
the incoming call is the number of the set caller ID. The device
will use the system ringtone for all other calls. When a ringtone
is selected but no caller ID is configured, the selected ring tone
will be used for all incoming calls.
System ringtone: adopt the North American standard by default.
The user can adjust the system ringtone' s frequencies and
cadences based on their country' s telecom standard.
These settings can be configured through various call progress
tone frequencies and cadences according to the standard of
country where the phone is located.
By default, call progress tones are set to North American
standard.
Frequencies should be configured with known values to avoid
uncomfortable high pitch sounds. ON is the period of ringing
(" On time"in ms) while OFF is the period of silence. In order
to set a continuous ring, OFF should set to zero. Otherwise it
will ring ON ms and a pause of OFF ms and then repeat the
pattern. Up to three cadences are supported.
The default value is No. If it is set to Yes, the call waiting will
be disabled.
The default value is No. If it is set to Yes, the call waiting tone
will not be played to remind user when there is an incoming
call, and only the LED blinks as the reminder.
Dial an IP address under the same LAN/VPN segment by
entering the last octet in the IP address.
In the Advanced Settings page, the Use Quick IP-call mode
option is set to No by fault. When it is set to Yes, and #XXX is
dialed (X is 0– 9 and XXX ≤ 255), the phone will make direct IP
call to aaa.bbb.ccc.XXX (aaa.bbb.ccc comes from the local IP
address regardless of the subnet mask).
#XX or #X are both the valid dialing format, and the leading 0 is
not required. See Quick IP Call Mode for details.
If it is set to Yes, the configuration changes through keypad are
disabled.
42
4 Configuration Guide