Console Basic Operation; Two Scene Control; Entering Two Scene Operation Mode - Philips 64331 Operation Manual

Operations Manual

CONSOLE BASIC OPERATION

Naming Conventions
When a key is referred to in the manual it will be in capital letters. For instance RECORD would refer to the record
button. A softkey command on the LCD screen will be written contained inside "". So for instance the "Enter" would
refer to a softkey option available on the LCD screen.
Note: All screen shots in the

1. Two Scene Control

In Two Scene operation, separate scenes are set up on PRESET A and PRESET B faders. The A MASTER and B
MASTER faders are used to crossfade between the two different scenes.

Entering Two Scene Operation Mode

There are two ways of entering into Two Scene mode:
If the TWO SCENE button is not lit at all:
1) Press the TWO SCENE button once and it will turn yellow.
2) Press the TWO SCENE button a second time and it will turn dark green.
3) You are now in Two Scene mode.
Note: If any channels on PRESET A or PRESET B are above 0% and the relevant PRESET A or PRESET B
MASTER faders are at full the intensity of those channels will snap on.
Fading into TWO SCENE mode is also possible. If the TWO SCENE button is not lit at all:
1) Press the TWO SCENE button once and it will turn yellow.
2) If the PRESET A or PRESET B FADERS are at the bottom move them to the top. This will cross fade in
any channels set above 0% on the PRESET A faders and the TWO SCENE button will turn dark green or;
3) If the PRESET A or PRESET B FADERS are at the top move them to the bottom and then move them to
the top. This will cross fade in any channels set above 0% on the PRESET A faders and the TWO SCENE
button will go dark green.
In most cases during Two Scene operation you will want to control 24 channels (12 channels on the 12/24 version) as
this is the basic control mode. However it is possible to access up to 48 channels (24 on the 12/24 version) by using
the 1-48 (1-24) and the 49-96(25-49) buttons. You can page between the pages to set the levels as you require.
Remember to re-page to lower these channels if you have set them. The LCD next to the channel numbers you have
selected will light up to represent the channels that you are working with on each fader bank.
1 2
CONSOLE BASIC OPERATION
"CONSOLE BASIC OPERATION" section are simulated for clarity.