Vga Set; Artnet Setup - Philips 64331 Operation Manual

Operations Manual
3) Select SOFTKEY D "DelALL" .
4) Select SOFTKEY A "Yes" to delete or SOFTKEY C "No" to exit without deleting.
Delete Single DMX Base
You will need to be in DMX Base mode.
To delete a single DMX base:
1) Press RECORD .
2) Select the FX Key of the show you wish to delete.
3) Select SOFTKEY C "Delete Base" .
4) Select SOFTKEY A "Yes" to delete or SOFTKEY C "No" to exit without deleting.

6. VGA Set

VGA Set is usually used to reset the VGA screen if the VGA card has been removed or if you do not have a VGA
monitor and wish to make the LCD your source of information for channel data, ML and LEDs. This function is on
the third screen of the console's Setup menu.
To access VGA set:
1) Press MENU .
2) Press SOFTKEY D "Next" two times.
3) Press SOFTKEY A "VGA Set" .
4) You have two choices - Disable VGA or Enable VGA .
a. Disable VGA . If you wish to disable the VGA monitor:
1) Press SOFTKEY A "Exit" .
2) Turn the console off and then on.
3) The LCD Display will now be your main display device.
b. Enable VGA . To enable the VGA monitor:
1) Press SOFTKEY D "Enter" this will reboot the console.
2) The VGA display your main display device.

7. ArtNet Setup

Instead of using your DMX connections you can send information from the console over an ArtNet Ethernet network.
To access ArtNet setup:
1) Press MENU .
2) Press SOFTKEY D "Next" two times.
3) Press SOFTKEY B "ArtNet Set" . The LCD display will appear as shown in Figure 75.
6 4
SET UP FUNCTIONS
Art Net
Menu
Release
DMX Base
FX
PL: 01 S000 T000
Figure 75: ArtNet Setup - LCD Display
OpPoll
A
View Device
B
ArtNet
C
ConFig
D
Exit