Philips 64331 Operation Manual page 39

• To store your changes use SOFTKEY D "Enter" .
Note: If you wish to leave this screen without storing any changes press the MENU button. It will return you to the
previous screen.
LED Patch
First you need to allocate each LED fixture in your rig to a preset fader on the console. The Preset A set of Faders
are used in LED mode to control LED fixtures. The fader will control the intensity of the fixture and the Flash button
under the fader will be used to select the fixture to allow programming of all the attributes associated with the fixture.
A LED usually has Red, Green and Blue colors but may also have others like Amber, White etc. These can also be
controlled and used.
The first step in patching the fixtures is to select it from the fixture library. To do this you will need to insert the USB
stick with the fixture library on it into the console.
To patch a LED fixture:
1) Select SOFTKEY A to enter LED Patch .
Menu
Release
DMX Base
FX
2) The SOFTKEY A "Back" and SOFTKEY B "Next" are used to navigate the list of Fixtures.
3) The SOFTKEY C "More" is used to access the next page of Fixtures.
4) SOFTKEY D "Enter" is used to select the Fixture you wish to use.
5) Use SOFTKEY D "Enter" to select the fixture that you want. The LCD screen will change to allow you to
set the start address for the fixture you have selected.
Menu
Release
DMX Base
FX
It is possible to change the DMX address using the FX 1 through FX 10 keys. (FX10 is 0).
The Flash buttons that have no fixture assigned to them will be flashing. Press a Flash button to assign a fixture to it.
Read 10 Fixture
Total: 10
01: SEL001
02: SEL002
03: SEL003
04: SEL004
Master: xxx
Figure 39: LED Patch - LCD Display
Fixture Patch
Pat.ABanDA
To DMX [019]
Press Bump
Button to Patch
Master: xxx
Figure 40: LED Fixture Selection - LCD Display
200 Plus Series Console
A
Back
B
Next
C
More
D
Enter
Other
A
Fix
B
C
D
Exit
37
LED Mode