Using Time To Playback Submasters Sequentially - Philips 64331 Operation Manual

2) Move PRESET A and PRESET B MASTERS to the bottom.
3) Press the NEXT key. It will turn blue. The flash button under Submaster 1 will flash yellow.
4) Raise the PRESET A and PRESET B MASTER faders. This will output Submaster 1 and its flash button
will turn yellow. Submaster 5's flash button will now be flashing yellow.
5) Lower PRESET A and PRESET B MASTER faders to the bottom. This will output Submaster 5.
6) Continue the sequence until you have run through all of the stored submasters.
7) To exit the Sequence move PRESET A MASTER fader to the bottom. The blue light in the NEXT button
will go out.
Note: It is possible to change Submaster pages during the sequential playback and the memories on the newly
selected page will then fade in and run in sequence the next time the PRESET A and PRESET B MASTER faders
are moved.

Using Time to Playback Submasters Sequentially

It is also possible to use times when playing back the Submasters sequentially. Make sure the FD/ST TIME button is
red by pressing the button as needed. When red, this indicates that the STEP RATE fader is in time mode. To apply
the time press SOFTKEY B and SOFTKEY C buttons on the right of the LCD, the text will invert its colors to show
the selection has occurred. This will apply the time on the STEP RATE FADER to the PRESET A and PRESET B
faders. Set the time to the desired level. When you move the PRESET A and PRESET B faders the time will now
be applied to the transition.
REV1.00
01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
50 50 50 33 33 FL FL FL
25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48
49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72
73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96
01 02 03 04 05 06 07 08 09 10 11 12
13 14 15 16 17 18 19 20 21 22 23 24
25 26 27 28 29 30 31 32 33 34 35 36
37 38 39 40 41 42 43 44 45 46 47 48
Figure 15: Using Time to Playback Submasters Sequentially - Video Monitor Display
Monitor showing a crossfade from Submaster 01 to 02 running. The time is set to 1.49 seconds and the lines in the
Preset display move to show the fade happening. The channel levels are shown changing in real time.
Strand Lighting
Submaster Preset
Page: 01 A
CrossFade
In 02 Out 01
FL
1.49 1.49
200 Plus Series Console
Submaster GM: FL
Effect
B FX Base
FX1 FX2 FX3
FX4 FX5 FX6
FX7 FX8 FX9
FL
FX10 FX11 FX12
Submaster Operation
21