Cli: Configuring Ip Address, Gateway, And Time-To-Live (Ttl) - HP ProCurve 6400cl Series Management And Configuration Manual

The Default IP
Configuration
Figure 8-2. Example of the Switch's Default IP Addressing
CLI: Configuring IP Address, Gateway, and Time-To-
Live (TTL)
IP Commands Used in This Section
show ip
ip address < mask-length >
ip address /< mask-bits >
ip default-gateway
ip ttl
Viewing the Current IP Configuration.
Syntax: show ip
This command displays the IP addressing for each VLAN
configured in the switch. If only the DEFAULT_VLAN exists,
then its IP configuration applies to all ports in the switch.
Where multiple VLANs are configured, the IP addressing is
listed per VLAN. The display includes switch-wide packet
time-to-live, and (if configured) the switch's default gateway
and Timep configuration.
(You can also use the show management command to display the IP addressing
and time server IP addressing configured on the switch. Refer to figure
9-6 on page 9-10.)
For example, in the factory-default configuration (no IP addressing assigned),
the switch's IP addressing appears as:
Configuring IP Addressing
IP Configuration
Page
8-7
8-8, 8-9
8-8, 8-9
8-11
8-11
8-7