Port Mode - HP ProCurve 6400cl Series Management And Configuration Manual

Figure 10-4. Example of a Show Interfaces Brief Command Listing
Figure 10-5. Example of a Show Interfaces Config Command Listing
Using the CLI To Enable or Disable Ports and Configure Port
Mode
You can configure one or more of the following port parameters. For details,
refer to table 10-1 on pages 10-3 thru 10-5.
Syntax: [no] interface < port-list >
[< disable | enable >]
Disables or enables the port for network traffic. Does not
use the no form of the command. (Default: enable.)
[speed-duplex < auto-10 |10-full | 10-half | 100-full | 100-half |auto| auto-
100 | 1000-full >]
Specifies the port's data transfer speed and mode. Does
not use the no form of the command. (Default: auto.)
Port Status and Basic Configuration
Viewing Port Status and Configuring Port Parameters
This screen shows current port operating status.
Note: The (per-port) Bcast Limit column appears only on the 3400cl and
6400cl switches. (The 5300xl switches apply a global broadcast limit.
3400cl/
6400cl
Switches
Only
This screen shows current
port configuration.
10-9