Cli: Viewing And Configuring Port Trunk Groups - HP ProCurve 6400cl Series Management And Configuration Manual

During the Save process, traffic on the ports configured for trunking will
be delayed for several seconds. If the Spanning Tree Protocol is enabled,
the delay may be up to 30 seconds.
8. Connect the trunked ports on the switch to the corresponding ports on
the opposite device. If you previously disabled any of the trunked ports
on the switch, enable them now. (See "Viewing Port Status and Configur­
ing Port Parameters" on page 10-2.)
Check the Event Log ("Using the Event Log To Identify Problem Sources" on
page C-27) to verify that the trunked ports are operating properly.
CLI: Viewing and Configuring Port Trunk
Groups
Trunk Status and Configuration Commands
show trunks
show lacp
trunk
interface < port-list > lacp
Using the CLI To View Port Trunks
You can list the trunk type and group for all ports on the switch or for selected
ports. You can also list LACP-only status information for LACP-configured
ports.
Listing Static Trunk Type and Group for All Ports or for Selected
Ports.
Syntax: show trunks [< port-list >]
Omitting the < port-list > parameter results in a static trunk
data listing for all LAN ports in the switch. For example, in
a switch where ports A4 and A5 belong to Trunk 1 and ports
A7 and A8 belong to Trunk 2, you have the options shown in
figures 12-6 and 12-7 for displaying port data for ports
belonging to static trunks.

CLI: Viewing and Configuring Port Trunk Groups

below
page 12-13
page 12-15
page 12-16
Port Trunking
12-11