Displaying the Current Rate-Limit Configuration
This command displays the per-port rate-limit configuration in the running
config file.
Syntax: show rate-limit [ port-list ]
Without [ port-list ], this command lists the rate-limit
configuration for all ports on the switch. With [ port-list ], this
command lists the rate-limit configuration for the specified
port(s). This command operates the same way in any CLI
context.
For example, if you wanted to view the rate-limiting configuration on the first
five ports in the module in slot "A":
Figure 13-1. Example of Listing the Rate-Limit Configuration
The show config command lists the per-port rate-limiting and Guaranteed
Minimum Bandwidth configuration in the startup-config file. (Note that con-
figuration changes performed with the CLI, but not followed by a write mem
command do not appear in the startup-config file.)
Ports A3-A5 are configured with a rate
limit of 60 %. (Ports A1 and A2 are not
configured for rate-limiting.)
Port Traffic Controls
Rate-Limiting
13-5