Viewing The Current Lldp Configuration - HP ProCurve 6400cl Series Management And Configuration Manual

In the default configuration, LLDP is enabled and in both transmit and receive
mode on all active ports. The LLDP configuration includes global settings that
apply to all active ports on the switch, and per-port settings that affect only
the operation of the specified ports.
Command
show lldp config
[ no ] lldp run
lldp refresh-interval
lldp holdtime-multiplier
lldpTxDelay
lldpReinitDelay
lldp enable-notification
lldpnotificationinterval
lldp admin-status < txonly | rxonly | tx_rx | disable >
lldp config < port-list > IpAddrEnable
lldp config < port-list > basicTlvEnable

Viewing the Current LLDP Configuration

Displaying the Global LLDP, Port Admin, and SNMP Notification
Status. This command displays the switch's general LLDP configuration
status, including some per-port information affecting advertisement traffic
and trap notifications.
Syntax show lldp config
Displays the LLDP global configuration, LLDP port status, and
SNMP notification status. For information on the individual
global and notification settings, refer to "CDP Command
Sets+Configuring LLDP Operation" on page 14-34. For infor­
mation on port admin status, refer to "Configuring Per-Port
LLDP Transmit and Receive Modes" on page 14-41.
Configuring for Network Management Applications
LLDP (Link-Layer Discovery Protocol)
Page
14-35
14-37
14-38
14-38
14-39
14-40
14-40
14-41
14-41
14-42
14-43
14-35