Listing And Displaying Startup-Config Files - HP ProCurve 6400cl Series Management And Configuration Manual

Listing and Displaying Startup-Config Files

Command
show config files
show config < filename >
Viewing the Startup-Config File Status with Multiple
Configuration Enabled
Rebooting the switch with software release E.09.xx or later automatically
enables the multiple configuration feature.
Syntax:
show config files
This command displays the available startup-config files on
the switch and the current use of each file.
id: Identifies the memory slot for each startup-config file
available on the switch. Software versions earlier than
E.09.xx always use the startup-config file in slot 1.
act: An asterisk (
corresponding startup-config file is currently in use.
pri: An asterisk (
corresponding startup-config file is currently assigned to the
primary boot path.
sec: An asterisk (
corresponding startup-config file is currently assigned to the
secondary boot path.
name: Shows the filename for each listed startup-config file in
the switch. Refer to "Renaming an Existing Startup-Config
File" on page 6-30 for the command you can use to change
existing startup-config filenames.
— Continued on the next page. —
Multiple Configuration Files on 5300xl Switches
Page
Below
6-27
*
) in this column indicates that the
*
) in this column indicates that the
*
) in this column indicates that the
Switch Memory and Configuration
6-25