Connectivity Setup And Tips; Setup The Logiq E9 For Dicom Communications; Utility -> Connectivity -> Tcp/Ip Screen - GE LOGIQ E9 Service Manual

D 5180483-100, R
IRECTION
Section 3-9

Connectivity Setup and Tips

Refer to the LOGIQ E9 Basic User Manual and see: Section
Communications (cont'd)" on page 3-41
TOPICS covered in this Section:
• Section
• Section
• Section
43
• Section
3-9-1

Setup the LOGIQ E9 for DICOM Communications

Table 3-7
1.
2.
3 - 40
PROPRIETARY TO GE
. 7
EV
3-9-1 "Setup the LOGIQ E9 for DICOM Communications" on page 3-40
3-9-2 "Devices, Services, Dataflows and Print Buttons" on page 3-42
3-9-3 "How to Get the LOGIQ E9 to Recognize another Device on the Network" on page 3-
3-9-4 "DICOM Image Storage Service" on page 3-43
Utility -> Connectivity -> TCP/IP screen
Enter the LOGIQ E9 computer name. This may be the same as the station name.
Enter the LOGIQ E9 IP address, subnet mask, default gateway and network speed.
For automatic assignment of IP address, subnet mask and default gateway, select DHCP.
NOTE: If possible, set the LOGIQ E9 Network Speed to match that of the Network switch. If in
doubt, set it to AutoDetect. Otherwise, transfer times can be two to five times longer, during
which the LOGIQ E9 will appear to be locked up. (If the Hard Drive activity light on the front of
the console is lit steady or blinks quickly, the LOGIQ E9 is most likely not hung.)
Section 3-9 - Connectivity Setup and Tips
LOGIQ E9 P
"3-9-1 Setup the LOGIQ E9 for DICOM
for more information.
S M
ROPRIETARY ERVICE ANUAL