Outputting A Comparison Result Of Time Data - Mitsubishi Electric MELSEC iQ-R Series Programming Manual

Outputting a comparison result of time data

TCMP(P)
RnPCPU RnPCPU
RnCPU RnENCPU
(Process) (Redundant)
• The RnCPU and RnENCPU with firmware version "17" or later support these instructions. (Use an engineering tool with version "1.020W" or later.)
These instructions compare the time data to be compared that is specified by (s1), (s2), and (s3) with the time data specified
by (s4), and according to the result (small, match, or large), (d), (d)+1, or (d)+2 is turned on.
Ladder
(s1) (s2) (s3)
FBD/LD
EN ENO
s1 d
s2
s3
s4
■Execution condition
Instruction
TCMP
TCMPP
Setting data
■Description, range, data type
Operand Description
(s1) Start device for storing the time data (hour) to be compared
(s2) Start device for storing the time data (minute) to be
compared
(s3) Start device for storing the time data (second) to be
compared
(s4) Start device for storing the time data (hour, minute, second)
to be compared
(d) Start device for storing the comparison result
EN Execution condition
ENO Execution result
RnSFCPU RnSFCPU
(Standard) (Safety)
(s4) (d)
Execution condition
ST
ENO:=TCMP(EN,s1,s2,s3,s4,d);
ENO:=TCMPP(EN,s1,s2,s3,s4,d);
Range Data type
0 to 23 16-bit signed binary
0 to 59 16-bit signed binary
0 to 59 16-bit signed binary

16-bit signed binary

Bit

Bit
 Bit
7 APPLICATION INSTRUCTIONS
Data type (label)
ANY16
ANY16
ANY16
ANY16_ARRAY
(Number of elements: 3)
ANYBIT_ARRAY
(Number of elements: 3)
BOOL
BOOL
1021
7.25 Clock Instructions
7