Mitsubishi Electric MELSEC iQ-R Series Programming Manual page 963

Precautions
In the following cases, the error completion signal in (d1)+1 is turned on and an error code is stored as the completion status
in the device (d2).
• The DBINSERT(P) instruction is executed during execution of the database access instruction.
• An identification number outside the range is specified by (s1).
• An identification number of a database which is not open is specified by (s1).
• A database built or operated with a programmable controller CPU with firmware version "28" or later is specified by (s1) for
a programmable controller CPU with firmware version earlier than "28".
• The table name specified by (s2) does not exist.
• The number of characters of the table name specified by (s2) exceeds 32.
• An out-of-range value is specified in (s3) for the number of fields to be added.
• An out-of-range field name is set in the field name specified by (s3)+1 to (s3)+.
• An out-of-range value is specified in (s4) for the number of records to be added.
• Database insertion processing failed.
• The range of the data for one record set in (s4)+2 does not match the size specified by (s4)+1.
Operation error
Error code Description
(SD0)
2820H The area specified by (s2), (s3), (s4), or (d1) exceeds the applicable range of the device/label used.
For the error code stored in the completion status of the operand, refer to the following.
Page 986 Error codes related to database access instructions
7 APPLICATION INSTRUCTIONS
7.21 Database Access Instructions
7
961