Transferring 16-Bit Binary Data Block (16 Bits) - Mitsubishi Electric MELSEC iQ-R Series Programming Manual

Transferring 16-bit binary data block (16 bits)

BMOV(P)
RnPCPU RnPCPU
RnCPU RnENCPU
(Process) (Redundant)
These instructions batch-transfer the (n) points (0 to 65535) of 16-bit binary data starting from the device specified.
Ladder
(s) (d) (n)
FBD/LD
EN ENO
s d
n
■Execution condition
Instruction
BMOV
BMOVP
Setting data
■Description, range, data type
Operand Description
(s) Start device where the transfer target data is stored
(d) Transfer destination start device
(n) Number of transfer data points
EN Execution condition
ENO Execution result
*1 When specifying setting data by using a label, define an array to secure enough operation area and specify an element of the array
label.
*2 Data types other than INT and WORD are available to the engineering tool with version "1.030G" or later (except for BOOL and
POINTER data type). (Available data types are the same as the ones to GX Works2.) Note that available data types are INT and WORD
(in range of ANY16) when "Yes" is selected for "Check the data type of instruction argument" of option settings.
For the option settings, refer to the following.
 GX Works3 Operating Manual
• In safety programs executed by the Safety CPU, only safety devices and safety labels of data types described in the table
can be used.
■Applicable devices
Operand Bit
X, Y, M, L, J\
SM, F, B, SB,
FX, FY
(s)  
 
(d)
(n)  
RnSFCPU RnSFCPU
(Standard) (Safety)
Execution condition
Word
T, ST, C, D, W, U\G, J\,
SD, SW, FD, R, U3E\(H)G
ZR, RD
 
 
 
ST
ENO:=BMOV(EN,s,n,d);
ENO:=BMOVP(EN,s,n,d);
Range Data type

16-bit signed binary

16-bit signed binary
0 to 65535 16-bit unsigned binary

Bit
 Bit
Double word Indirect
Z LT, LST, LZ
LC
  
  
  
Data type (label)
*1*2
ANY16
*1*2
ANY16
*2
ANY16
BOOL
BOOL
Constant Others
specification
K, H E $
    
    
    
6 BASIC INSTRUCTIONS
6.7 Data Transfer Instructions
6
503