Mitsubishi Electric MELSEC iQ-R Series Programming Manual page 192

Processing details
• This instruction changes the device status as follows when the execution command turns on.
Device
Bit device
Bit-specified word device
• The device that has been turned on remains on even after the execution command turns off. The device that has been
turned on can be turned off by using the RST instruction.
X5
X7
• When the execution command is off, the device status does not change.
Operation error
There is no operation error.
When X is used, specify a device number that is not used in actual input. If the number that is used in actual
input is specified, the data of actual input is written over the input device (X) specified by the SET instruction.
5 SEQUENCE INSTRUCTIONS
190
5.3 Output Instructions
X5 OFF
SET Y10
RST Y10
X7 OFF
Y10 OFF
Status
Turns on the coil or contact.
Sets the specified bit to 1.
ON
ON
ON