Converting The Edge Relay Operation Result Into A Pulse - Mitsubishi Electric MELSEC iQ-R Series Programming Manual

Converting the edge relay operation result into a pulse

EGP, EGF
RnPCPU RnPCPU
RnCPU RnENCPU
(Process) (Redundant)
• EGP: Converting the edge relay operation result into a pulse (rising edge)
This instruction stores the operation result up to the EGP instruction in the edge relay (V). The instruction turns on at the rising
edge (off to on) of the operation result.
• EGF: Converting the edge relay operation result into a pulse (falling edge)
This instruction stores the operation result up to the EGF instruction in the edge relay (V). The instruction turns on at the
falling edge (on to off) of the operation result.
Ladder
(d)
EGP
(d)
EGF
FBD/LD
EN ENO
d
■Execution condition
Instruction
EGP
EGF
Setting data
■Description, range, data type
Operand Description
(d) Edge relay number for storing operation result
EN Execution condition
ENO Execution result
*1 Only bit type labels assigned to the device (V) can be used.
■Applicable devices
Operand Bit
X, Y, M, L,
SM, F, B, SB,
FX, FY

(d)
RnSFCPU RnSFCPU
(Standard) (Safety)
Execution condition
Word
J\ T, ST, C, D, W, U\G, J\,
SD, SW, FD, R, U3E\(H)G
ZR, RD
  
ST
ENO:=EGP(EN,d);
ENO:=EGF(EN,d);
Range Data type
 Bit

Bit
 Bit
Double word
Z LT, LST, LZ
LC
  
Data type (label)
*1
ANY_BOOL
BOOL
BOOL
Indirect Constant Others
specification (V)
K, H E $
    
5 SEQUENCE INSTRUCTIONS
5.2 Association Instructions
5
173