Issue 7.0
11.5
5 - 124
2.
Use the charger AC adapter to connect the charger's AC jack to a
standard electrical outlet.
3.
Place the handset in th echarger with the display facing forward. the
HANDSET STATUS LED should turn on; if it doesn't, reseat the handset
or try plugging the AC adapter into a different outlet.
4.
Place the spare battery (if available) in the back section of the charger;
the BATTERY STATUS LED should turn on. (Pull the battery latch back
slightly to fit the battery in the slot.)
Figure 5-153 ML440 - Insert Handset into Charger
Charge each battery approximately 10 hours before use.
.
Powering on the Handset
To power up the handset, press and hold End until the display flashes once
(about three seconds). The handset searches for the base station or multi-cell
chain it is registered to and connects to the unit with the strongest signal.
Installing DT300/DT700 Series (DTL/ITL) Digital and IP Multiline Terminals
UNIVERGE SV8100