Settings; Track Widener - Husqvarna DXR250 Operator's Manual

Track widener

The machine is equipped with track wideners for
increased stability when working with the machine.
• Width with track widener: 1110 mm (44 in)
• Width without track widener: 780 mm (31 in)
Assembly
Outriggers DXR270, DXR300, DXR310
• Extend the outriggers.
• Shut off the machine. Disconnect the power cable
and place it so that it cannot be connected by mistake.
• Loosen screws A and B.
• Slide washer C to one side.
• Pull the side of the tracks out a sufficient distance to
enable the track widener to be fitted.
• The holes of the track widener must be facing the
machine.
• Move the side of the track towards the machine.
• Tighten the screws. M24 (500Nm), M10 (47Nm)
To dismantle, follow the instructions in the reverse order.

SETTINGS

Dozer blades DXR250
• Extend down the dozer blades.
• Shut off the machine. Disconnect the power cable
and place it so that it cannot be connected by mistake.
• Remove the nuts (A).
• Loosen bolts (C) and nuts (B).
• Move washer (D) to the side.
• Pull the side of the tracks out a sufficient distance to
enable the track widener to be fitted.
• The holes of the track widener must be facing the
machine.
• Move the side of the track towards the machine.
• Tighten bolts and nuts.
To dismantle, follow the instructions in the reverse order.
–
English 37