Table of Contents
Advertisement
Note
Note
Note
Note
4-10 Configuring the Emulator
6
The emulator will operate in mode 6. (single chip
normal mode)
7
The emulator will operate in mode 7. (single chip
advanced mode)
It is recommended to specify operation mode number in this
configuration, since the emulator does not work fine when MD0,MD1
and MD2 are not steady.
When you emulate H8/3004/05, cf mode = ext is not available. You
have to configure processor mode using cf mode=<mode_num>
When mismatch takes place between cf chip and cf mode, the emulator
will operate in mode which you don't specify.
Executing this command will drive the emulator into the reset state.
Advertisement
Table of Contents
