Table of Contents
Advertisement
Note
Note
Note
Note
4-14 Configuring the Emulator
Refresh cycles may be traced regardless of this configuration in order
to disassemble the trace list correctly.
Executing this command will drive the emulator into the reset state.
cf trst
The trst (target reset) configuration item allows you to specify whether
or not the emulator responds to /RES and /STBY signals from the
target system during foreground operation. When running the
background monitor, the emulator ignores such signals.
M> cf trst=en
When you enable target system reset with the above command, the
emulator will respond to /RES input during foreground operation.
M> cf trst=dis
When disabled, the emulator won't respond to /RES and /STBY inputs
from the target system.
/RES and /STBY signals are always ignored during background
operation regardless of this configuration.
The H8/3003 dose not support hardware standby mode, and /STBY
input will be given the emulator /RES input.
Advertisement
Table of Contents
