Chapter 10
System Status Check
10.6
Powering Off
■
When Controlling by the Power Switch
This section explains how to use the Power switch to turn off the ETERNUS AF.
1
Press and hold the Power switch of the controller enclosure for four seconds or more.
Power switch
The READY LED ( ) on the controller enclosure is turned off.
•
After power-off, wait for about one minute before turning power on again.
If the Power switch is pressed again between the time of the READY LED (
•
POWER LED (
2
The power of the ETERNUS AF is disconnected.
When the power is disconnected, the POWER LED ( ) of the controller enclosure and the POWER LEDs
(
) of the drive enclosures are turned off.
■
When a Power Synchronized Unit Is Used
If the server is turned off, the ETERNUS AF is also turned off.
) turning off, the ETERNUS AF power may turn on.
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
Controller enclosure
157
) turning off and the
P3AG-1832-04ENZ0