Fujitsu ETERNUS AF250 S2 Configuration Manual page 3

Fujitsu would like to thank you for purchasing the FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 (here-
inafter referred to as ETERNUS AF).
The ETERNUS AF is designed to be connected to Fujitsu servers (Fujitsu SPARC Servers, PRIMEQUEST, or PRI-
MERGY) or non-Fujitsu servers.
This manual describes how to install the ETERNUS AF and how to start the operation.
This manual is intended for use of the ETERNUS AF in regions other than Japan.
Please carefully review the information outlined in this manual.
About This Manual
Organization
This manual is composed of the following eleven chapters:
• "Chapter 1 Component Names" (page 17)
This chapter provides components names of the ETERNUS AF.
"Chapter 2 Rack Installation" (page 22)
•
This chapter describes the procedure for installing the ETERNUS AF in a rack.
"Chapter 3 Checking the Configuration Environment" (page 34)
•
This chapter describes the environment required for system configuration.
"Chapter 4 Connecting Cables" (page 44)
•
This chapter explains how to connect various cables to the ETERNUS AF.
"Chapter 5 General Settings" (page 55)
•
This chapter describes the basic settings for the ETERNUS AF.
"Chapter 6 Monitoring Settings" (page 85)
•
This chapter describes the settings required to monitor the ETERNUS AF.
"Chapter 7 Power Control Setup" (page 105)
•
This chapter describes the settings required for power control of the ETERNUS AF.
• "Chapter 8 SAN Connection Settings" (page 109)
This chapter describes the settings required to use the ETERNUS AF with a SAN connection.
"Chapter 9 Advanced Copy Settings" (page 141)
•
This chapter describes the settings required to operate Advanced Copy.
"Chapter 10 System Status Check" (page 152)
•
This chapter describes the status check for the ETERNUS AF after system configuration.
"Chapter 11 Solution Configuration" (page 158)
•
This chapter describes storage solutions using the ETERNUS AF.
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
3
Preface
Fourth Edition
December 2017
P3AG-1832-04ENZ0