Table 5.2 Operation Volume Creation - Fujitsu ETERNUS AF250 S2 Configuration Manual

Chapter 5 General Settings
5.7 RAID Configuration Settings
To perform a backup with SnapOPC+, two types of backup volumes (generation data management area and
expansion area where copy data is saved) must be prepared in addition to one for operation. For details
about creation of backup volume, refer to
79) and "5.7.4 Copy Data Destination Volume (SDPV) Creation" (page

Table 5.2 Operation Volume Creation

Usage
Operation volume (copy source)
Generation management volume
Copy data destination volume
*1: Though the copy source capacity is specified during creation, the capacity allocated to sdv is approxi-
mately 0.1% of the copy source capacity.
When creation is finished, the volume is automatically formatted. After volume creation, Standard and
SDV become accessible from the host when host affinity setting is completed.
SDPV becomes available when formatting starts after creation.
The procedure to create an operation volume is as follows:
1
Click the [Volume] tab on the navigation of the ETERNUS Web GUI screen.
The [Volume] screen appears.
2
In [Action], click [Create].
The [Create Volume] screen appears.
3
Set the required items in the [Create Volume] screen and click the [Create] button.
Name: main
Capacity: 1TB
Type: Standard
RAID Group / TPP Selection: Manual
Manual Setting: RG0
Item
main
sdv0 - 6
sdpv
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
"5.7.3 Generation Management Volume (SDV) Creation" (page
Capacity
1TB
1TB (*1)
500GB
77
80).
Volume type
Standard
Snap Data Volume
Snap Data Pool Volume
P3AG-1832-04ENZ0