Fujitsu ETERNUS AF250 S2 Configuration Manual page 46

Chapter 4 Connecting Cables
4.1 Host Interface Cable Connection
Step 1
(1)
Remove the connector cover attached to the port of the SFP+ module and open the lever.
Keep the removed connector cover in a safe place where it will not be lost.
(2)
Check the direction of the SFP+ module and insert it all the way into the port cage of the host
interface.
Install the SFP+ module in Port#0 first, and then Port#1.
(3)
Close the SFP+ module's lever.
is not required if the host interface (CA) is iSCSI 10Gbit/s (10GBASE-T).
SFP+ module
Lever
Host interface Host interface
(CA#0)
Controller 0
(CM#0)
Port#0 Port#1 Port#0
SFP+ module (Insertion direction)
Topside
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
Host interface
(CA#1) (CA#0)
Port#1 Port#0
46
Host interface
(CA#1)
Controller 1
(CM#1)
Port#1 Port#0 Port#1
P3AG-1832-04ENZ0