Table of Contents
Advertisement
Radio Connections
Follow the Radio Connections instructions described under Programming the Astro IV&D
Digital Radio using CPS above.
Radio Disassembly
Follow the Radio Disassembly instructions described under Programming the Astro IV&D
Digital Radio using CPS above.
CPS Programming Settings
Before programming the radio, read the codeplug file from the radio and save it to your PC
using the File >Read Device command in the CPS (DSP version R06.00.00 for radio firmware
R06.01.00.) Open the codeplug file in the CPS and set the parameters as follows.
Procedure 21-9 How to Program the XTL5000/XTL2500 Analog Radio
1.
In the CPS, click on the codeplug in the tree view to view and select the items below or
select them from the Feature menu.
2.
Under Radio Configuration, double-click on Radio Wide.
a.
1) Change TX Power Level High for Freq. Range A from 53.5 to 15.
b.
c.
3.
Double-click on Controls.
a.
b.
c.
1) Set VIP In for VIP 1, VIP 2, and VIP 3 to Blank.
2) Set VIP Out for VIP 1 to MOSCAD CG.
3) Set VIP Out for VIP 2 to MOSCAD TXE/CM.
4) Set VIP Out for VIP 3 to NULL.
4.
Double-click on Conventional ->Conventional Personality -> Conventional Personality 1.
a.
b.
c.
d.
In the Transmit Power Levels tab, reduce the radio power level to low: Change
TX Power Level Low for Freq. Range A from 28.0 to 10.
In the Advanced tab, make sure that "MOSCAD Data Enable" is enabled. Set
Extended DEK to Enable and Ignition Switch to Soft Power Off.
In the Time Out Timer tab, make sure the Time # is set to 3 (for 60 sec).
Click on Control Head.
Make sure the Control Head is O5(M5) for new models and W4 for old models.
Click on Radio VIP.
In the Rx Options tab, set Unmute/Mute Type to UnMute, Or Mute.
Set Rx Voice/Signal Type to Non-Astro.
Enable (check) Rx Emphasis and Busy LED.
In the Tx Options tab, make sure that the Time Out Timer is set to 3 (for 60 sec).
21-15
Radio Types and Installation Kits
Advertisement
Table of Contents
