Table of Contents
Advertisement
Assembling the TB Holder Parts
Procedure 5-1 Assembling the TB Holder Parts
If the TB holder kit is ordered, follow the procedure below. (See Figure 5-6.)
1) Prepare the cable by cutting the wires to fit the TBs. Connect the wires of the user-
assembled cables to the TBs, following the pin descriptions on the module panel label
(where pin 1 is at the top of first TB and so on downwards.)
2) Place the TBs onto the left part of the TB holder plastic.
3) Add the top ejector handle, the code key and the positioner.
4) Close the right side of the plastic TB holder over the left side.
5) Screw together the assembly using the three screws provided in the kit.
Note the lower screw holds the positioner into place.)
6) Insert the lower ejector handle at the bottom of the TB holder.
7) Slide the metal axis into lower ejector handle from the side.
Once the TB holder is assembled, it can be connected to the I/O module.
Figure 5-5 Terminal Block (TB) Holder-Front and Back View
5-5
I/O Modules
Advertisement
Table of Contents
