Table of Contents
Advertisement
DO/DI FET Module Specifications
Total Number of I/Os
I/O Arrangement
Counter Inputs
Counter Input Frequency
Max. DC Input Voltage
Input "ON" Resistance
Input "OFF" Resistance
Fast Capture Resolution
Event Time Tagging Resolution
Input Current
Input Filtering
Counter Input Filtering
Output Type
Output Voltage Range
DO Frequency
DO Output Current
Output Fail State
Diagnostic LEDs
User Connection
Cable and TB Holder
Module Replacement
Input / Output Isolation
Input Insulation
Operating Voltage
Power Consumption
Dimensions
Weight
16; 32
Two or four group of 8 I/Os with shared common
Each group can be configured as FET DO or dry contact DI.
Selectable combinations (32 DO/DI): 32 DO/8 DI+24 DO/
16 DI+16 DO/24 DI+8 DO/32 DI
Selectable combinations (16 DO/DI): 16 DO/8 DI+8 DO/16 DI
32 DI: 20 first inputs can be used as counter inputs.
16 DI: All 16 inputs can be used as counter inputs.
0 - 1 KHz, minimum pulse width 500 µS. Note: Although filters are
defined in steps of 0.2mSec and 0.05mSec, it is relevant only from 1mSec
and above.
Max. 30 V DC (relative to input common)
0-4 kΩ
≥50 kΩ
1 mS (Interrupt upon change of state)
1 mS (Interrupt upon change of state)
Max. 0.3 mA (when the input is shorted)
0 to 50.8 mS (programmable in 0.2 mSec steps), minimum effective filter
value - 1mSec
0 to 12.75 mS (programmable in 0.05 mSec steps), minimum effective
filter value - 1mSec
MOSFET
5-30 V DC (user supplied voltage)
Max. 1 KHz (resistive load)
Max. 500 mA sink current (resistive load)
Configurable output state on CPU fail: On, Off or 'last value'
LED per each input / output status, module error LED
4 Terminal Blocks (3.5mm pitch), Maximum 18 AWG
20- or 40-wire cable braid with Terminal Block holder connector, 26 AWG
Hot swap replacement– module extraction / insertion under voltage
1.5 kV between input/output and module logic
Insulation resistance 100 MΩ @ 500 V DC per IEC60255-5
10.8-16 V DC and 3.3 V DC (from the motherboard connector)
Refer to Appendix D: ACE3600 Maximum Power Ratings.
37 mm W x 225 mm H x 180 mm D (1.5" W x 8.7" H x 7.1" D)
Approx. 0.25 Kg (0.55 Lb)
8-10
Digital Output/Digital Input FET Module
Advertisement
Table of Contents
