Table of Contents
Advertisement
Figure 4-3 depicts a plug-in port board attached to the ACE3600 CPU module.
Figure 4-3 Plug-In Port in CPU Module
Procedure 4-1 describes how to connect a plug-in port to the CPU.
Procedure 4-1 How to Connect a Plug-in Port to the CPU
1) Remove the CPU module from the RTU.
2) Remove the cover from the desired opening on the front panel.
3) Connect two supporting pins with screws to the plug-in port.
4) Place the plug-in board with the RJ-45 connector facing the panel. Carefully insert the
plug-in board connector into the appropriate connector on the CPU board.
For Ethernet 10/100 MB, use the J14 connector on the CPU (Plug-in 1 only.)
For all other plug-in ports, use the J5 (Plug-in 1) or J6 (plug-in 2) connector.
5) Connect the two supporting pins with screws to the other side of the CPU board.
6) Replace the CPU module in the slot.
Supporting
Pins
Plug-in 1
Supporting
Pins
Plug-in 2
4-8
CPU Module
Advertisement
Table of Contents
