Table of Contents
Advertisement
5.
Press 'A' and the IP Protocol selection menu will appear.
6.
Select the IP Protocol you would like to use. The following modes are supported:
TCP – Cannot be used for ACE3600.
UDP – to be used as ACE3600external modem.
PPP – to be used for MDLC over IP (Not relevant for External Modem.)
Press 'B' to select the UDP port.
7.
If you selected UDP above, you will be prompted to select the Topology. You have the
following choices:
Point to Point is used if you have a single AP and a single remote unit.
Point to MultiPoint is used if you transmit to a single radio. This radio is the point, and
all radios are the multipoint. For example: An FNE is a point, and all other RTUs are
multipoint. No RTU to RTU is provided.
MultiPoint to MultiPoint works like a real radio where any radio (RTU) can
communicate with another.
Press 'C' (Multipoint to MultiPoint) to enable routing between any RTU to any RTU.
8.
Next, set the values for the Multicast IP Address and Multicast Port. These are the
addresses used when transmitting and receiving. They should be the same on all radios.
Press 'A' and enter "224.254.1.1" for the Multicast IP Address.
9.
Press 'B' and enter "30011" for the Multicast Port.
10. Press 'C' to continue the wizard until the final screen, or abort it by pressing 'Q'.
11. When the final wizard screen appears prompting you to "Change values (if necessary)
for UDP Data Connection Settings", do not change any values. Press 'Q' to quit wizard.
12. The COM2 Serial Data Port values will be displayed. Press 'G' and set the appropriate
Baud Rate (from 1200 bps to 115200 bps.)
13. The Hardware Configuration values will be displayed. Press 'G' to select the 8N1
hardware configuration for the port.
14. It is recommended to have Hardware Flow Control on the serial port enabled. When
prompted, press 'A' to enable Hardware Flow Control.
15. When prompted to select the Serial Packet Mode, press 'A' to use the default value
(Seamless Mode.) Press Q to exit wizard.
21-68
Radio Types and Installation Kits
Advertisement
Table of Contents
