Installing Fe/Ge Ethernet Cables - Huawei DBS3900 Installation Manual

DBS3900 (ICR)
Installation Guide
Figure 15-37 Installing E1/T1 cables
Step 2 Tighten the screws on the DB26 male connectors to 0.4 N·m (3.54 lbf·in.).
Step 3 Route the other end of the cable through the right side on the top of the IMB03. Then connect
it to the external transmission device.
Step 4 Route the cables along the right side of the cabinet according to the instructions in
Requirements, and use cable ties to bind the cables.
Step 5 Label the installed cables according to the instructions in Attaching an L-Shaped Label.
----End

15.11.2 Installing FE/GE Ethernet Cables

This section describes the procedure and precautions for installing FE/GE Ethernet cables.
Procedure
Step 1 Connect one end of an FE/GE Ethernet cable to the FE0 port on the GTMU, and one end of
another FE/GE Ethernet cable to the FE0 port on the WMPT or FE/GE0 port on the UMPT, as
shown in
Issue 12 (2015-04-30)
Figure 15-38.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
15 Installing Cables
15.1 Cabling
143