Installing Fe/Ge Optical Cables - Huawei DBS3900 Installation Manual

DBS3900 (ICR)
Installation Guide
Figure 15-38 Installing FE/GE Ethernet cables
Step 2 Route the other end of the cable through the right side on the top of the IMB03. Then connect
it to the external transmission device.
Step 3 Route the cables along the right side of the cabinet according to the instructions in
Requirements, and use cable ties to bind the cables.
Step 4 Label the installed cables according to the instructions in Attaching an L-Shaped Label.
----End

15.11.3 Installing FE/GE Optical Cables

This section describes the procedure and precautions for installing FE/GE optical cables.
Context
l
Issue 12 (2015-04-30)
NOTE
l An FE/GE Ethernet cable must be a shielded straight-through cable.
l This section describes how to install FE/GE Ethernet cables in a GU base station using independent
transmission. For the FE/GE Ethernet cable connections in other configuration scenarios, see section
"Transmission Cable Connections" in the DBS3900 Hardware Description.
Single-mode optical modules are labeled as SM and multimode optical modules are labeled
as MM.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
15 Installing Cables
15.1 Cabling
144