Modifying And Adapting The Simulation Graphics - Siemens SINUMERIK 840D sl Operating Manual
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
Switching a single block on and off
7.8
Modifying and adapting the simulation graphics
7.8.1
Enlarging or reducing the graphical representation
Precondition
The simulation or the simultaneous recording is started.
Procedure
...
Universal
Operating Manual, 05/2017, A5E40868517
3.
Press the "Back" and "Start SBL" softkeys.
The pending program block is simulated and then stops.
4.
Press "Start SBL" as many times as you want to simulate a single program
block.
5.
Press the "Program control" and the "Single block" softkeys to exist the
single block mode.
Press the <CTRL> and <S> keys simultaneously to enable and disable the
single block mode.
1.
Press the <+> and <-> keys if you wish to enlarge or reduce the graphic
display.
The graphic display enlarged or reduced from the center.
- OR -
Press the "Details" and "Zoom +" softkeys if you wish to increase the size
of the segment.
- OR -
7.8 Modifying and adapting the simulation graphics
Simulating machining
183
Advertisement
Table of Contents
