Default Settings For Manual Mode - Siemens SINUMERIK 840D sl Operating Manual

Working in manual mode

5.6 Default settings for manual mode

Procedure
5.6 Default settings for manual mode
Specify the configurations for the manual mode in the "Settings for manual operation" window.
Default settings
Settings
Type of feedrate
Setup feedrate G94
Setup feedrate G95
Variable increment
Spindle speed
96
1. <RESET> interrupts the power supply to the machine and any running
part program.
2. After a power supply interruption, switch on the controller.
3. Select the JOG operating mode.
4. Press the Menu forward key.
5. Press the "Retract" softkey.
The "Retract Tool" window opens.
The softkey is available only when an active tool and retraction data are
present.
6. Select the "WCS" coordinate system on the machine control panel.
7. Use the traversing keys (e.g. Z +) to traverse the tool from the workpiece
according to the retraction axis displayed in the "Retract Tool" window.
8. To exit the window, press the "Retract" softkey again when the tool is at
the desired position.
Meaning
Here, you select the type of feedrate.
● G94: Axis feedrate/linear feedrate
● G95: Revolutional feedrate
Enter the desired feedrate in mm/min.
Enter the desired feedrate in mm/rev.
For variable increments, enter the desired increment when traversing axes.
Here, enter the desired spindle speed in rpm.
Operating Manual, 05/2017, A5E40868517
Universal