Configuring Dnp3 Protocol Signals - ABB 650 series Engineering Manual

Section 9
DNP3 communication engineering
9.3
106
IEC11000425 V1 EN
Figure 74: Selecting the signals into the DNP signal list

Configuring DNP3 protocol signals

1. Save the actual project configuration in PCM600 to make all signals visible for
CMT.
Direct configured hardware channels in the application
configuration (see
Do not configure these hardware channels to be sent by DNP3,
as they are not event-handled.
Figure 75) appear in CMT (see
1MRK 511 261-UEN -
IEC11000425-1-en.vsd
Figure 76).
650 series
Engineering Manual