Troubleshooting - Silvercrest 102870 Operating Instructions Manual

Troubleshooting

PROBLEM
The appliance is not
working. The indicator
light above the ON/OFF
button e fails to come on.
The appliance does not
start the cooking process.
E0 is shown on one of the
displays 0/u.
E2 is shown on one of the
displays 0/u.
E3 is shown on one of the
displays 0/u.
E4 is shown on one of the
displays 0/u.
E5 is shown on one of the
displays 0/u.
E6 is shown on one of the
displays 0/u.
SDI 3500 A1
POSSIBLE CAUSE
The plug is not connected.
The appliance is damaged.
There is no vessel on the
respective hob 1/2.
The vessel is not suitable
for induction hobs.
There is no vessel on the
respective hob 1/2.
The temperature sensor
beneath the hob 1/2 is
defective or there is a short
circuit.
The appliance is being
supplied with too much
voltage (>270 V).
The appliance is not being
supplied with enough voltage
(<150 V).
The appliance has overheated.
The appliance has overheated.
POSSIBLE
SOLUTIONS
Connect the appliance to
a mains power socket.
Contact the Customer
Service department.
Place a suitable vessel on
the respective hob 1/2.
Use a suitable vessel
(see the "Suitable
cookware" section).
Place a suitable vessel on
the respective hob 1/2.
Disconnect the plug from
the mains power socket
and contact the Customer
Service department.
Check and ensure that the
appliance is connected
to a properly installed
mains power socket with
220–240 V ~ , 50 Hz.
Check and ensure that the
appliance is connected
to a properly installed
mains power socket with
220–240 V ~ , 50 Hz.
Disconnect the plug from
the mains power socket
and wait until the appliance
has cooled down.
Disconnect the plug from
the mains power socket
and wait until the appliance
has cooled down.
GB
IE
15