WARNING:
Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before working inside your
your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Topics:
•
Prerequisites
•
Procedure
Prerequisites
1
Remove the
computer
cover.
2
Remove the
front
bezel.
3
Follow the procedure from step 1 to step 6 in
Procedure
1
Press the securing clip and disconnect the power-supply unit cable (ATX_CPU) from the system board.
2
Press the securing clip and disconnect the power-supply unit cable (ATX_SYS) from the system board.
3
Note the power-supply unit cable routing and remove the power-supply unit cable from the routing guides on the chassis.
4
Remove the three screws (#6-32xL6.35) that secure the power-supply unit to the chassis.
Removing the power-supply unit
computer. After working inside your computer, follow the instructions in
"Removing the optical
www.dell.com/
drive".
Removing the power-supply unit
28
After working inside
51