Table of Contents
Advertisement
Degree of protection of the HMI device
NOTICE
Degree of protection IP65 for HMI device
When enclosure openings or the connection compartment are not closed, the HMI device
does not meet the specified degree of protection.
Ensure that the enclosure is closed as specified by the regulations.
Device
HMI device, front and rear panel
RFID tag
3.4
WLAN properties
Adhere to the installation guidelines when installing the WLAN. You can find more additional
information in the System manual "Basics on Setting up an Industrial Wireless LAN"
(http://support.automation.siemens.com/WW/view/en/9975764).
Plan the WLAN for a maximum of four HMI devices.
When adding a WLAN participant, make sure that you observe the conditions described in
the document "Wireless LAN in a PROFINET IO Environment". The conditions vary
depending on the operating mode and the requirement for PNIO refresh times. See
Guideline for the Use of Industrial Wireless LAN in a PROFINET IO Environment
(http://support.automation.siemens.com/WW/view/en/31938420).
NOTICE
Communication interference possible
Communication interference cannot be excluded if you do not check the local wireless
conditions prior to start-up.
Check your local wireless conditions prior to start-up. When planning the wireless channels,
mode 802.11a is preferable.
Ad hoc network
An ad hoc network cannot be used in conjunction with the HMI device.
Wireless Teach Pendant F IWLAN V2
Operating Instructions, 08/2010, A5E02453837-01
Degree of protection in accordance with IEC 60529
IP65
IP65
PRELIMINARY II
1.7.2010
Planning the use
3.4 WLAN properties
51
Advertisement
Table of Contents
