Table of Contents
Advertisement
4.6
Switching on and testing the HMI device
When the HMI device is initially put into operation, there is no project. Ethernet is set as the
data transfer channel.
Requirement
● A charged main rechargeable battery is inserted in the HMI device.
Procedure
Proceed as follows:
1. Briefly press the "ON/OFF" button.
The "PWR" LED lights up – see section "LED display (Page 85)". The display then lights.
A progress bar is displayed during startup.
The loader is displayed once the operating system has started.
If a charged main rechargeable battery is inserted, the "BAT" LED lights up. The HMI
device automatically switches to "Transfer" mode if the following two requirements are
met:
– No project is loaded on the device.
– At least one data channel has been configured.
The following dialog appears:
2. Press the "Cancel" button.
The transfer is canceled. The Loader appears.
Wireless Teach Pendant F IWLAN V2
Operating Instructions, 08/2010, A5E02453837-01
PRELIMINARY II
Mounting and connection
4.6 Switching on and testing the HMI device
1.7.2010
81
Advertisement
Table of Contents
