Chapter 2 Preparations
(b)
Using an optional RAID controller (N8103-171/149/150/151/152)
Jumper on motherboard (SWRAID)
Change the jumper setting to 1-2 (Disabled).
Change the jumper setting of the backplane for the hard disk drive.
Backplane for 3.5-inch hard disk drive (J3)
Backplane for 2.5-inch hard disk drive (J3)
Motherboard
N8103-171/149/150/151/
152
Note
When installing an optional RAID Controller, start the BIOS Setup utility, select PCI
Configuration from the Advanced menu, and then make sure that the parameter
of PCI Slot xx ROM (xx is PCI slot number) is set to Enabled.
Important
Do not change the mode to hibernate when building a RAID System.
Express5800/R110f-1E User's Guide
1. Installing Internal Optional Devices
3 2 1
3 2 1
Disabled
Enabled
(Factory seting)
SWRAID
Onboard SATA
N8103-1171/149/150/151/
controller
152
Onboard SATA
controller
63