Table of Contents
Advertisement
Chapter 3 Setup
2.4
Cases that Require Setting Changes
Specify parameters according to the following table when your system matches "Description". The list of
SETUP parameters and factory settings are described in Chapter 2 (1. System BIOS) in "Maintenance
Guide".
Category
Basic
Change date and time
On/Off NumLock on power ON
On/Off the function to display
NEC logo during POST
Memory
Configure the memory after the
DIMM is added or exchanged.
Optional
Install RAID Controller board
board
When an optional board is
installed, set to [Disabled] for
Option ROM for all PCI devices
except for the boot device.
Boot
Change the boot order of
devices
Use remote power on feature
(from modem)
Use remote power on feature
(from RTC alarm)
Control from HW console
terminal
Security
Set a password to restrict
operation of SETUP.
Set a password to restrict
booting.
130
Description
Main → System Date
Main → System Time
Boot → Bootup Numlock State
Boot → Quite Boot → Disabled
Advanced → Memory Configuration →
Memory Retest → Yes
Advanced → PCI Configuration → PCI
Device Controller and Option ROM
Settings → PCI Slot n Option ROM →
Enabled
Advanced → PCI Configuration → PCI
Device Controller and Option ROM
Settings → PCI Slot n Option ROM →
Enabled
Advanced → PCI Configuration → PCI
Device Controller and Option ROM
Settings → LAN1 Option ROM Scan →
Disabled
Boot → Boot Option Priorities →
Change the boot priority
Advanced → Advanced Chipset
Configuration → Wake On Ring →
Enabled
Advanced → Advanced Chipset
Configuration → Wake On RTC Alarm
→ Enabled
Advanced → Serial Port Configuration
→ Change respective setting.
Security → Administrator Password →
Security → User password
Security → Password on Boot →
Enabled
Express5800/R110f-1E User's Guide
To be changed
Configurable on OS
By pressing <Esc> key, prevent
the display of the logo.
After rebooting, the Memory
Retest setting changes to No
automatically.
n is PCI slot number of the RAID
Controller
"n": Slot number in the PCI
device (except for the boot
device)
Option ROM on LAN1 must be
disabled.
After a password is set, the
entry of password is displayed
when SETUP is launched.
You can select this parameter
after you set a password.
2. System BIOS Setup
Remark
Advertisement
Table of Contents
