Cases That Require Changes - NEC Express5800/R310g-E4 User Manual

Chapter 3 Setup
2.4

Cases that Require Changes

Use SETUP to change a parameter in the following cases. Other than cases described below, do not change
the settings. A list of SETUP parameters and factory settings are described in Chapter 3 (1. System BIOS) in
"Maintenance Guide".
Category
Basic Change date and time
On/Off NumLock at power
ON
Hide the NEC logo during
POST
Option Enable Option ROM Scan of
board installed option board
To perform physical
Boot
formatting, set a Legacy
BIOS mode temporarily.
To perform physical
formatting, set a Legacy
BIOS mode temporarily and
reset.
Change the boot order of
devices
Set a password
Security
Restrict bootup by entering
password
UPS When the server is supplied
Power link with power from UPS, always
turn on the power.
If the server is turned off by
using POWER switch, leave it
OFF even when UPS
supplies power.
Keep the power OFF even
when UPS supplies power.
Description
Main  System Date
Main  System Time
Boot  Bootup Numlock State  ON
Boot  Quite Boot  Disabled
Advanced  PCI Configuration PCI
Device Controller and Option ROM
Settings  PCIx Slot Option ROM 
Enabled
Boot  Boot Mode  Legacy
Boot  Boot Mode  UEFI
Boot  Boot Option Priorities 
Change the boot priority
Security  Administrator Password
 Set a password
Security  User Password  Set a
password
Security  Password on Boot 
Enabled
Server  Power Control
Configuration  AC-LINK  Power
ON
Server  Power Control
Configuration  AC-LINK  Last
State
Server  Power Control
Configuration  AC-LINK  Stay off
Express5800/R310g-E4, R320g-E4, R320g-M4 User's Guide
To be changed
Pressing <Esc> key hides
the NEC logo tentatively.
X is PCI slot number of the
option board
For physical formatting, see
Chapter 3 (3.3 Physical
Formatting of the Hard Disk
Drive) in "Maintenance
Guide".
When you use
EXPRESSBUILDER, set
the highest priority to
CD/DVD.
If password is set, a
message requesting
password is displayed at
the next SETUP execution.
Can be selected when
password is set.
2. BIOS Setup Utility (SETUP)
Remark
71