Chapter 3 Setup
2.4
Cases that Require Changes
Use SETUP to change a parameter in the following cases. Other than cases described below, do not change
the settings. The list of SETUP parameters and factory settings are described in Chapter 2 (1. System BIOS)
in "Maintenance Guide".
Category
Basic
Change date and time
On/Off NumLock on power ON
On/Off the function to display
the NEC logo during POST
Optional
When an optional board is
board
installed, set to Disabled for
Option ROM for all PCI devices
except for the boot device.
Memory
Configure the memory after the
DIMM is added or exchanged.
Boot
Set to UEFI in Boot mode
depending on the installed OS.
Set to Legacy in Boot mode
depending on the installed OS.
Change the boot order of
devices
Use remote power on feature
(from RTC alarm)
Control from HW console
terminal
116
Description
Main System Date
Main System Time
Boot Bootup Numlock State
Boot Quite Boot Disabled
Advanced PCI Configuration PCI
Device Controller and Option ROM
Settings PCI Slot n Option ROM
Enabled
Advanced PCI Configuration PCI
Device Controller and Option ROM
Settings LAN1 Option ROM Scan
Disabled
Advanced Memory Configuration
Memory Retest Yes
Boot Boot Mode UEFI
The following OS must be set to UEFI:
- Windows Server 2016
- Windows Server 2012
- Windows Server 2012 R2
- VMware ESXi 6
- VMware ESXi 6.5 Later
Boot Boot Mode Legacy
The following OS must be set to Legacy:
- Windows Server 2008 R2
Boot Boot Option Priorities
Change the boot priority
Advanced Advanced Chipset
Configuration Wake On RTC Alarm
Enabled
Advanced Serial Port Configuration
Change respective setting.
Express5800/T110i-S User's Guide
To be changed
Configurable on OS
By pressing <Esc> key, prevent
the display of the logo.
n is PCI slot number of the RAID
controller
Option ROM on LAN1 must be
disabled.
After rebooting, the Memory
Retest setting changes to No
automatically.
For details, see Installation
Guide.
For details, see Installation
Guide.
2. BIOS Setup Utility (SETUP)
Remark