Table of Contents
Advertisement
Chapter 3 Setup
4. POST displays the result of memory test, CPU status, and other messages.
5. After a while, the following message is displayed on the screen.
Press <F2> SETUP, <F3> Internal Flash Memory, <F4> ROM Utility, <F12> Network
You can call the functions below upon completion of POST by pressing the function key.
<F2> key:
<F3> key:
<F4> key:
<F12> key: Boot from network.
6. When the boot mode is legacy BIOS and a controller which has the dedicated BIOS (such as a SAS
controller) is installed, a message that prompts you to start the utility is displayed.
Example: optional RAID controller
Press <Ctrl> <H> for Web BIOS
The utility starts by pressing <Ctrl> + <H> keys.
Example: on-board RAID controller
Press <Ctrl> <M> to Run LSI Software RAID Configuration Utility
The utility starts by pressing <Ctrl> + <M> keys.
For details on the utility, refer to the manual supplied with each optional board.
Depending on the hardware configuration, the message "Press Any Key" or "Press <F1> Key"
prompts a key entry by optional device. Continue to operate after checking the manual of the optional
device.
7. If you set a password in BIOS Setup Utility, the password entry appears upon successful completion of
POST.
Three incorrect password entries disable the server to boot. In such a case, turn off the power, wait at
least ten seconds, and then turn on the server.
Tips
The value of memory capacity shown in the message may be smaller than the
actual physical memory depending on the hardware configuration. This applies to
the information in SETUP and system information of the operating system
Tips
When Server Power Measurement Policy is One time or Always, the power
measurement message appears instead of the above message. Wait until the
measurement is complete.
Run BIOS Setup Utility (SETUP). For details, see Chapter 3 (2. BIOS Setup Utility
(SETUP)).
Run EXPRESSBUILDER from Internal Flash Memory. For details, see Chapter 3 (4.
EXPRESSBUILDER).
Note
If bootable CD/DVD is inserted into optical disk drive, the system starts from
CD/DVD even if <F3> key is pressed.
Run the offline tool. For details, see Chapter 1 (9. Offline Tools) in "Maintenance Guide".
Important
Do not set a password before OS is installed.
Express5800/T110i-S User's Guide
1. Turning on the Server
111
Advertisement
Table of Contents
