Table of Contents
Advertisement
Chapter 2 Preparations
Install a 2.5-inch HDD cage in the server by using the following procedure.
1.
See Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
2.
To remove the side cover and the front bezel, see Chapter 2 (1.3 Removing the Side Cover and 1.4
Removing the Front Bezel).
3.
Mount the rollers that come with the HDD cage on
the holes inside the HDD bay (10 places).
4.
Insert the HDD cage into the HDD bay. The "C side"
must face upward. Do not push the HDD cage to the
end for connecting cables later.
5.
Connect the interface cable and power cable to the HDD cage. Use the interface cable that comes
with the HDD cage. Use the power cable connected to the motherboard in advance. For details of
cable connection, see Chapter 2 (1.15.1 Internal interface cables) described later.
6.
Push the HDD cage to the end. Insert one side of the
lock plate into the slit of the chassis. Push the lock
plate in the direction shown by the arrow to lock the
HDD cage.
Important
Make sure to insert the lock plate into the groove of the chassis correctly. Incorrect
installation causes the removal of the side cover to be impossible.
Express5800/T110i-S User's Guide
1. Installing Internal Optional Devices
65
Advertisement
Table of Contents
