Table of Contents
Advertisement
Chapter 2 Preparations
Connecting the FBU control board to RAID controller
Install the control board of the flash backup unit to the RAID controller while referring to the User's Guide for
the RAID controller.
Connecting the flash backup unit control cable
To connect the flash backup unit control cable into the flash backup unit, see the following figure.
Check the form of the connector and connect the cable straight into the connector.
Getting ready to install the flash backup unit
1.
See Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
2.
To remove the side cover and the front bezel, see Chapter 2 (1.3 Removing the Side Cover and
1.4 Removing the Front Bezel).
48
Tips
The following diagram shows an example of N8103-176/177/178. The control
board part is installed to N8103-206/207/208 as standard.
Express5800/T110i-S User's Guide
1. Installing Internal Optional Devices
Advertisement
Table of Contents
