Cases That Require Setting Changes - NEC EXP339 User Manual

Chapter 3 Setup
2.4

Cases that Require Setting Changes

Specify parameters according to the following table when your system matches "Description". Other than cases
described below, do not change the settings. The list of SETUP parameters and factory settings are described
in Chapter 2 (1. System BIOS) in "Maintenance Guide".
Category
Basic Change date and time
On/Off NumLock on power ON Boot  Bootup Numlock State
On/Off the function to display
the NEC logo during POST
Optional A RAID controller is installed
board
When an optional board is
installed besides the RAID
controller, set to Disabled for
Option ROM for all PCI
devices except for the boot
device.
Boot Change the boot order of
devices
Control from HW console
terminal
Set to Disabled in X2APIC
Opt Out depending on the
installed OS.
108
Description
Main  System Date
Main  System Time
Boot  Quite Boot  Disabled
Advanced  PCI Subsystem  PCI
Express Slot n I/O ROM  Enabled
Advanced  PCI Subsystem  PCI
Express Slot n I/O ROM  Disabled
Boot  FIXED BOOT ORDER
Priorities  Change the boot priority
Advanced  Serial Port Console
Redirection  Change respective
setting.
Chipset  System Agent (SA)
Configuration  X2APIC Opt Out
Disabled
The following OSs are applicable:
－ Red Hat Enterprise Linux 7
－ Windows Server 2019
－ Windows Server 2016
－ VMware ESXi 6.5
－ VMware ESXi 6.7
Express5800/T110j User's Guide
To be changed
Configurable on OS
By pressing <Esc> key,
prevent the display of the logo.
n is PCI slot number of the
RAID controller
n is PCI slot number of the
RAID controller
For details, see Installation
Guide.
2. System BIOS Setup
Remark